|
|
Post by hellonewman on Sept 10, 2005 20:53:29 GMT -5
I installed a Viper 790XV with aftermarket actuators for the door locks and they work. but it doesn't seem that they are strong enough to move the locks.
Any ideas out there??
|
|
|
|
Post by Whiteymx6 on Oct 11, 2005 10:15:57 GMT -5
I wonder if they are getting enough juice?
I am not an electronics guru that's for sure.
|
|
|
|
Post by BoiWitdaToyz on Oct 11, 2005 10:46:13 GMT -5
hell he barely knows how to spell Electronics. hahaha.
But he may be right newman, check to see if you hooked it up to a strong enough source of power.
|
|
|
|
Post by skyler on Oct 11, 2005 10:49:38 GMT -5
that or the ground may not be clean... make sure there is no paint or rust on the metal near you ground cause that will affect your power as well. Just sand it down if there is.
|
|
|
|
Post by Whiteymx6 on Oct 11, 2005 12:06:09 GMT -5
Well, he says it works, so there is power......but not enough to unlock the doors.
I would say try lubricating all the working parts of the locking mechanism on each door before going and messing with the electrical.
|
|
